Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 413

61239 [Channel %1: ] Block %2: Tool change point lies within retraction area!
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The tool change point has to be far enough outside the retraction area so that when the revolver is swiveled, no tool extends
into the retraction area.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify another tool change point.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61240 %[[Channel %1: ] Block %2: %]Wrong feed type
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The feed type is not possible for this machining.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check feed type
Programm Clear alarm with the RESET key. Restart part program
continuation:
61241 [Channel %1: ] Block %2: Retraction plane not defined for this machining direction
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: No retraction plane has been defined for the selected machining direction.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Define the missing retraction plane.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61242 [Channel %1: ] Block %2: Wrong machine direction
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The machining direction has been specified incorrectly.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the programmed machining direction.
Programm Clear alarm with the RESET key. Restart part program
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
413