Error Messages And Error Handling; General Information; Error Handling Within Cycles; Cycle Alarms - Siemens SINUMERIK 802D sl Programming And Operating Manual

4.13

Error messages and error handling

4.13.1

General information

If error conditions are detected in the cycles, an alarm is generated and the execution of the
cycle is aborted.
The cycles continue to output messages in the dialog line of the control. These message will
not interrupt the program execution.
Note
For more information on errors and required responses, as well as messages output in the
control's dialog line, please refer to the section for the relevant cycle.
4.13.2

Error handling within cycles

Alarms with numbers between 61000 and 62999 generated in the cycles. This range of
numbers, in turn, is divided again with regard to alarm responses and cancel criteria. The er-
ror text that is displayed together with the alarm number gives you more detailed information
on the error cause.
Alarm number
61000 ... 61999
62000 ... 62999
4.13.3

Cycle alarms

Table 4-11 Cycle alarms
Alarm Alarm text
number
61501 Simulation is active
61502 No tool compensation active
61503 Cutting edge compensatioin left
or right
61505 Free travel path < 1mm
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Clearing criteri- Alarm Response
on
NC_RESET Block preparation in the NC is aborted
Clear key Program execution is not interrupted; display only
Source Explanation, Remedy
CYCLE ...
416, 420 Reset simulation
410, 411, 412, A workpiece number must be programmed
413, 414, 415,
416, 420
410, 411, 412, A tool compensation value must be programmed
413, 414, 415,
416, 420
420 Increase travel path
4.13 Error messages and error handling
Cycles
4-43