Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 403

Remedy: Deselection of multi-axis transformation with TRAFOOF
or deselection of Toolcarrier (TCARR) with CYCLE800()
61197 [Channel %1: ] Block %2: Swiveling - plane not allowed -> Error code %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Error code:
Programm Clear alarm with the RESET key. Restart part program
continuation:
61198 [Channel %1: ] Block %2: Swiveling with kinematic chain -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Programm Clear alarm with the RESET key. Restart part program
continuation:
61199 [Channel %1: ] Block %2: Swiveling - tool not allowed -> Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Error is also output if no swivel data record is active and only tool approach is programmed.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: A CYCLE800 must be called with a valid swivel data record before orientation.
Error code:
A: Orientation of tool and change of swivel data record not allowed
Programm Clear alarm with the RESET key. Restart part program
continuation:
61200 [Channel %1: ] Block %2: Too many elements in machining block
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The machining block contains too many elements.
Remedy: Check the machining block, delete some elements if required.
61201 [Channel %1: ] Block %2: Wrong sequence in machining block
Parameters: %1 = Channel number
%2 = Block number, label
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
403