Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 485

Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Programm Clear alarm with the RESET key. Restart part program
continuation:
61841 [Channel %1: ] Block %2: Necessary GUD for automatic servo optimization is missing: %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Missing GUD
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Programm Clear alarm with the RESET key. Restart part program
continuation:
61842 [Channel %1: ] Block %2: Calling a cycle of the automatic servo optimization is not permissible:
%3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Caller
Explanation: Calling CYCLE75x is not permissible because it is called by a cycle from the standard or manufacturer cycle directory.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: You need the manufacturer password to call CYCLE75x.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61850 [channel %1: ] block %2: cylinder surface transformation not released
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Cylinder surface transformation not released for ShopMill.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Programm Clear alarm with the RESET key. Restart part program
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
485