Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 409
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61223
[Channel %1: ] Block %2: Approach path too small
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The approach path must not be less than zero.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Enter a greater value for the approach path.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61224
[Channel %1: ] Block %2: Retract path too small
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The retract path must not be less than zero.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Enter a greater value for the retract path.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61225
[Channel %1: ] Block %2: Swivel data record unknown
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
An attempt was made to access a swivel data block which has not been defined.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select another swivel data block or define a new swivel data block.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61226
[Channel %1: ] Block %2: Swivel head cannot be exchanged
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The parameter "Swivel data block" is set to "No". In spite of this, an attempt has been made to change the swivel head.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Set the parameter "Swivel data block" in the setup screen "Rotary axes" to "Automatic" or "Manual".
Programm
Clear alarm with the RESET key. Restart part program
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
409
Hide quick links:
Advertisement
Table of Contents
