Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 253
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program. Deselect thread cutting or tapping.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
16763
[Channel %1: ] Block %2 axis %3 programmed speed is illegal (zero or negative)
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Explanation:
A spindle speed (S value) was programmed with the value zero or with a negative value.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
The programmed spindle speed (S value) must be positive. Depending on the application case, the value zero can be
accepted (e.g. G25 S0).
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
16765
[Channel %1: ] Block %2 motion synchronous action: %3 following spindle/axis missing
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
Explanation:
The following spindle/axis has not been written in the part program.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Modify part program.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
16766
[Channel %1: ] Block %2 motion synchronous action: %3 string cannot be interpreted
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
Explanation:
A coupling has been switched on in which a non-interpretable string has been written (e.g. block change behavior).
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Modify part program.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
16767
[Channel %1: ] Block %2 motion synchronous action: %3 leading spindle/axis missing
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
Explanation:
The master spindle/axis has not been programmed in the part program.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
253
Hide quick links:
Advertisement
Table of Contents
