Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 280

SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Reaction: Interface signals are set.
Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique.
2. If unique numbering is not necessary for subsequent operations, do not use the command.
Programm Clear alarm with the Delete key or NC START.
continuation:
17190 [Channel %1: ] Block %2 illegal T number %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
Explanation: In the displayed block, a tool is accessed that is not defined and is therefore not available. The tool has been named by
its T number, its name or its name and duplo number.
If the function T=magazine location is activated and programmed, the programmed T number indicates the magazine
location number. The alarm can then indicate that the programmed magazine location number is illegal.
If the function T=magazine location is activated and programmed, and the multitool function is also activated and
programmed in the program line MTL, the alarm can also indicate that there is no multitool at the location programmed
with T=magazine location
or that there is no tool at the multitool location programmed with MTL.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check tool call in the NC part program:
- Is the correct tool number T.. programmed?
- T=magazine location programming: Is the correct magazine location number programmed?
- MTL programming: Is there a multitool at the programmed magazine location or is there a tool at the programmed multitool
location?
- Are tool parameters P1 - P25 defined? The dimensions of the tool edge must have been entered previously either via
the operator panel or the V.24 interface.
Description of the system variables $P_DP x [n, m]
n ... Associated tool number T
m ... Tool edge number D
x ... Parameter number P
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
17191 [Channel %1: ] Block %2 T= %3 not existing, program %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number or T identifier
%4 = Program name
Explanation: A tool identifier which the NCK does not recognize was programmed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
280
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual