Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 247

Explanation: Diameter programming has been activated although no transverse axis with diameter programming has been applied.
Transverse axes can be applied with MD20100 $MC_DIAMETER_AX_DEF or MD30460 $MA_BASE_FUNCTION_MASK
bit2 for diameter programming.
Diameter programming can be applied through:
- basic position DIAMON or DIAM90 of the G 29 group during booting
- programming of DIAMON or DIAM90
- programming of DIAMONA[AX], DIAM90A[AX] or DAC, DIC, RAC, RIC
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department.
When programming DIAMON/DIAM90, a traverse axis must be configured via MD20100 $MC_DIAMETER_AX_DEF.
When programming DIAMONA[AX], DIAM90A[AX] or DAC, DIC, RAC, RIC, the AX axis must be a transverse axis for
diameter programming configured via MD30460 $MA_BASE_FUNCTION_MASK bit2.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
16600 [Channel %1: ] Block %2 spindle %3 gear stage change not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle number
Explanation: The programmed speed is outside the speed range of the set gear stage. In order to execute the programmed speed, the
gear stage must be changed. In order to be able to execute the automatic gear stage change (M40 is active), the spindle
must be in speed control operation.
The alarm will no longer be output after having set bit 30 (0x40000000) in MD11410 $MN_SUPPRESS_ALARM_MASK.
However, the function will not be affected by this.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: The changeover to speed control operation is performed by programming M3, M4 or M5. The M functions can be written
together with the S word in the same block.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
16605 [Channel %1: ] Block %2 Spindle %3 Gear stage change in %4 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle number
%4 = Gear stage
Explanation: A gear stage change for the spindle will not be possible, if:
- thread cutting (G33, G34, G35) is active
- the spindle is active as master or slave spindle in a coupling
- the spindle is being positioned
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: The gear stage is to be set prior to the corresponding machining step.
If it is necessary, however, to change the gear stage within one of the above mentioned functions, this function must be
switched off for the time of the gear stage change. Thread cutting is deselected with G1; synchronous spindle coupling is
switched off with COUPOF; the spindle positioning operation is exited with M3, M4 or M5.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
247