Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 126

SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: After selecting transformation or frame, reprogram the geometry axis now operating as positioning axis (e.g. with WAITP)
in order to revert the status to "geometry axis.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
10805 [Channel %1: ] Block %2 repositioning after switch of geometry axes or transformation
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: In the asynchronous subroutine the assignment of geometry axes to channel axes was changed or the active transformation
modified.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Programm Clear alarm with the RESET key. Restart part program
continuation:
10810 [Channel %1: ] Block %2 master spindle not defined
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The function "Revolutional feedrate" (with G95 or G96), or "Rigid tapping" (with G331/G332) has been programmed,
although no master spindle is defined from which the speed could be derived.
For the definition the MD 20090 $MC_SPIND_DEF_MASTER_SPIND is available for the default or the keyword SETMS
in the part program, thus allowing each spindle of the channel to be redefined as master spindle.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Preset the master spindle with MD20090 $MC_SPIND_DEF_MASTER_SPIND[n]=m (n ... channel index, m ... spindel no.)
or define it with an identifier in an NC part program before a G function that requires a master spindle is programmed.
The machine axis that is to be operated as a spindle must be equipped in MD35000
$MA_SPIND_ASSIGN_TO_MACHAX[n]=m (n ... machine axis index, m ... spindle no.) with a spindle number. Additionally,
the MD20070 $MC_AXCONF_MACHAX_USED[n]=m (n ... channel axis index, m ... machine axis index) must be used to
assign it to a channel (channel axis index 1 or 2).
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
10820 [Channel %1: ] Rotary axis/spindle %2 not defined
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Explanation: Revolutional feed has been programmed for contouring and synchronous axes or for an axis/spindle. However, the rotary
axis/spindle from which the feed is to be deduced is not available.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy: Correct part program or set the SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE correctly.
126
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual