Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 387

61124 [Channel %1: ] Block %2: Infeed width is not programmed
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: With active simulation without tool, a value for the infeed width _MIDA must always be programmed.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61125 [Channel %1: ] Block %2: Technology selection parameter incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check technology selection parameter (_TECHNO).
Programm Clear alarm with the RESET key. Restart part program
continuation:
61126 [Channel %1: ] Block %2: Thread length too short
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program lower spindle speed or raise reference point (reference plane).
Programm Clear alarm with the RESET key. Restart part program
continuation:
61127 [Channel %1: ] Block %2: Wrong definition of tapping axis transformation ratio (machine data)
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis.
Programm Clear alarm with the RESET key. Restart part program
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
387