Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 102

SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
10635 [Channel %1: ] Axis %2, tool radius compensation is inactive for type %3 working area limitation,
reason: no milling or drilling tool.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = 0: BCS, 1: WCS / SZS
Explanation: The tool radius compensation of the working area limitation of the stated axis is not taken into account.
Reason: The tool must be of type milling cutter or drill.
The alarm is reported in JOG mode.
Reaction: Alarm display.
Remedy: The tool radius compensation for working area limitations in JOG mode can only be taken into account for milling or drilling
tools.
Programm Clear alarm with the Delete key or NC START.
continuation:
10636 [Channel %1: ] Axis %2, tool radius compensation is inactive for type %3 working area limitation,
reason: Transformation is active.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = 0: BCS, 1: WCS / SZS
Explanation: The tool radius compensation of the working area limitation of the stated axis is not taken into account.
Reason: A transformation is active.
The alarm is reported in JOG mode.
Reaction: Alarm display.
Remedy: The tool radius compensation for working area limitations in JOG mode cannot be taken into account if transfomation is
active.
Programm Clear alarm with the Delete key or NC START.
continuation:
10637 [Channel %1: ] Axis %2, tool radius compensation is inactive for type %3 working area limitation,
reason: Tool not active.
Parameters: %1 = Channel number
%2 = Axis, spindle
%3 = 0: BCS, 1: WCS / SZS
Explanation: The tool radius compensation of the working area limitation of the stated axis is not taken into account.
Reason: No tool is active.
The alarm is reported in JOG mode.
Reaction: Alarm display.
Remedy: The tool radius compensation for working area limitations in JOG mode cannot be taken into account wihout an active tool.
Programm Clear alarm with the Delete key or NC START.
continuation:
10650 [Channel %1: ] Axis %2 incorrect gantry machine data, error code %3
Parameters: %1 = Channel number
%2 = Axis
%3 = Error no.
Explanation: An incorrect value was entered in the gantry-specific axial machine data. Further information can be derived from the error
number.
- Error no. = 1 => either an incorrect gantry unit has been entered or the designation of the following axis is incorrect.
- Error no. = 2 => master axis has been specified more than once.
102
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual