Configuring The Ethernet Connection - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual

This window is intended for servicing. All programs provided by the HMI are displayed with
their version numbers. By reloading software components, the version numbers can be
different from each other.
3.9

Configuring the Ethernet connection

Ethernet connections
The following Ethernet connections are possible between the control system and a PC:
● Direct connection: direct connection between the control system and PC
● Network connection: integrating the control system into an existing Ethernet network
Establishing a direct connection
Proceed as follows to establish a direct connection between the control system and a PC:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
1. Connect the control system with the PC using an Ethernet cable.
2. Select the desired operating area on the PPU.
+
3. Press this key to view the extended softkeys.
4. Enter the main screen of the service control options through the fol‐
lowing softkey operations:
Operating in the system data management operating area
3.9 Configuring the Ethernet connection
→
41