Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 65

Explanation: An auxiliary function has been illegally configured.
Predefined auxiliary functions cannot be reconfigured by user-defined auxiliary functions.
See:
MD22010 $MC_AUXFU_ASSIGN_TYPE[n]
MD22020 $MC_AUXFU_ASSIGN_EXTENSION[n]
MD22030 $MC_AUXFU_ASSIGN_VALUE[n]
MD22035 $MC_AUXFU_ASSIGN_SPEC[n]
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Reconfigure the auxiliary function.
Programm Clear alarm with the RESET key. Restart part program
continuation:
4200 [Channel %1: ] Geometry axis %2 must not be declared a rotary axis
Parameters: %1 = Channel number
%2 = Axis name
Explanation: The geometry axes represent a Cartesian coordinate system and therefore the declaration of a geometry axis as rotary
axis leads to a definition conflict.
Reaction: NC not ready.
Mode group not ready, also effective for single axes.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department.
Remove rotary axis declaration for this machine axis.
For this purpose, the geometry axis index for the displayed geometry axis must be determined by means of MD20060
$MC_AXCONF_GEOAX_NAME_TAB. The channel axis number is stored with the same index in MD20050
$MC_AXCONF_GEOAX_ASSIGN_TAB. The channel axis number minus 1 provides the channel axis index under which
the machine axis number is found in MD20070 $MC_AXCONF_MACHAX_USED.
Programm Switch control OFF - ON.
continuation:
4210 [Channel %1: ] Spindle %2 declaration as rotary axis missing
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Explanation: If a machine axis is to be operated as a spindle, this machine axis must be declared as a rotary axis.
Reaction: NC not ready.
Mode group not ready, also effective for single axes.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Set rotary axis declaration for this machine axis in the axis-
specific MD30300 $MA_IS_ROT_AX.
Programm Switch control OFF - ON.
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
65