Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 472

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check infeed DX or DZ in connection with tip length of the tool in tool management.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61713 %[[Channel %1: ] Block %2: %]Tool radius larger than half the tip width
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check tool radius and tip width of tool (plunge cutter, cutting tool)
Programm Clear alarm with the RESET key. Restart part program
continuation:
61714 %[[Channel %1: ] Block %2: %]Error during contour turning %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: -103: Machining not possible
-121: Cancellation due to lack of memory
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: -103: Check contour or the position of the tool does not match the contour
-121: Check contour and technological data
Call the SIEMENS hotline
Programm Clear alarm with the RESET key. Restart part program
continuation:
61730 %[[Channel %1: ] Block %2: %]Machining range outside delimitation
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check machining range and delimitation
Programm Clear alarm with the RESET key. Restart part program
continuation:
61731 %[[Channel %1: ] Block %2: %]Unable to determine contour direction
Parameters: %1 = Channel number
%2 = Block number, label
472
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual