Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 83

6436 [Channel %1: ] Block %2 command '%3' cannot be programmed. Function '%4' has not been
activated.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Programmed command
%4 = Function identifier
Explanation: The command cannot be programmed due to the lack of a function enable or activation.
Function code (4th parameter):
1 = Flat D numbers
2 = Tool monitoring
3 = Magazine management
4 = Multitools
5 = T=Magazine location number
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC program
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
6437 [Channel %1: ] Block %2 Command '%3' cannot be programmed. Function '%4' is activated.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Programmed command
%4 = Function identifier
Explanation: The command cannot be programmed as the specified function is active.
Function code (4th parameter):
1 = Flat D numbers
2 = Tool monitoring
3 = Magazine management
4 = Multitools
5 = T=Magazine location number
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC program
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
6452 [Channel %1: ] Block %2 tool change not possible. Tool holder/spindle number = %3 not defined.
Parameters: %1 = Channel ID
%2 = Block number, label
%3 = Tool holder/spindle number
Explanation: The desired tool change is not possible. The toolholder/spindle number has not been defined.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
83