Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 386

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
61120 [Channel %1: ] Block %2: Thread type inside / outside not defined
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The thread type (internal/external) was not defined.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The internal/external thread type must be entered.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61121 [Channel %1: ] Block %2: Number of teeth per cutting edge is missing
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: No value was entered for the number of teeth per cutting edge.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Enter the number of teeth/cutting edges for the active tool into the tool list.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61122 [Channel %1: ] Block %2: Safety distance incorrectly defined in plane
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The safety clearance is negative or zero. This is not allowed.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Define the safety clearance.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61123 [Channel %1: ] Block %2: CYCLE72 cannot be simulated
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Programm Clear alarm with the RESET key. Restart part program
continuation:
386
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual