Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 424

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
61283 [Channel %1: ] Block %2: direct approach not possible, as tool change required
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: After block search a position is to be reached by direct approach, but a tool change is required before.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: First execute a manual tool change, then restart the block search.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61284 [Channel %1: ] Block %2: starting point cannot be approached without collision. Pre-position tool
manually
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The starting point cannot be approached without collisions.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Preposition the tool manually.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61285 [Channel %1: ] Block %2: parking position is below return plane XRA.
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The parking position is below retraction plane XRA.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Move the parking position above retraction plane XRA.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61286 [Channel %1: ] Block %2: machining not possible, check tool angle.
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Machining not possible with the specified tool.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a suitable tool.
Programm Clear alarm with the RESET key. Restart part program
continuation:
424
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual