Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 396

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Programm Clear alarm with the RESET key. Restart part program
continuation:
61163 [Channel %1: ] Block %2: Infeed width in the plane too large
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: --
61164 [Channel %1: ] Block %2: Transformation has incorrect type %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: The transformation has the incorrect type. Correct the transformation set up.
61165 [Channel %1: ] Block %2: Transformation set up incorrectly: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: The transformation has been set up incorrectly. Correct the transformation set up.
61166 [Channel %1: ] Block %2: Check machine data: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: The machine data must be checked. Adapt the setting of the machine data.
61167 [Channel %1: ] Block %2: Transformation not set up: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: The specified transformation is not set up. Set up the transformation.
61168 [Channel %1: ] Block %2: Incorrect machining plane: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: The machining plane is incorrect. Program correct machining plane.
61169 [Channel %1: ] Block %2: Spindle incorrectly programmed
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: An incorrect spindle was programmed.
Remedy: Change the spindle selection.
61170 [Channel %1: ] Block %2: Incorrect block plane (%4)
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: An invalid block plane was used.
396
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual