Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 422

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
61275 [Channel %1: ] Block %2: Target point violates software limit switch!
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Due to a swivel action, the end point is outside the software limit switches.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select another retraction plane or approach a suitable interpolation point.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61276 [Channel %1: ] Block %2: External tool diameter required for restrictions
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Outer tool diameter required in case of delimitations.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify the outer tool diameter.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61277 [Channel %1: ] Block %2: Tool diameter larger than restriction
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Tool diameter larger than delimitation.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use a smaller tool.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61278 [Channel %1: ] Block %2: If tool angle is larger than 90°, both tool diameters must be equal
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: For tool angles larger than 90°, the two tool diameters must be identical.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct the tool angle or the tool diameters.
Programm Clear alarm with the RESET key. Restart part program
continuation:
422
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual