Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 365

61008 [Channel %1: ] Block %2: No tool active
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Alarm triggered by following cycles:
Remedy: Select a tool.
61009 [Channel %1: ] Block %2: Active tool number = 0
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: No tool (T) has been programmed before the cycle call.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program tool (T).
Programm Clear alarm with the RESET key. Restart part program
continuation:
61010 [Channel %1: ] Block %2: Finishing allowance too large
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The finishing allowance for the base is greater than the total depth.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reduce finishing allowance.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61011 [Channel %1: ] Block %2: Scaling not permissible
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: A scale factor is active which is illegal for this cycle.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify scale factor.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61012 %[[Channel %1: ] Block %2: %]Different scaling in planes
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
365