Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 478

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Measuring system (G group: 13 (G70, G71, G700, G710)) must be the same in both the leading and following channels.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61752 %[[Channel %1: ] Block %2: %]Cutting edge positions or cutting directions of the tools are different
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Cutting edge position and cutting direction of the tools must be the same in guide and following channel.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61753 %[[channel %1: ] block %2: %]Difference in tool radii too large
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Tool radii may not be greater than the finishing allowance at maximum for rough cutting.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61754 %[[channel %1: ] block %2: %]Tool radii must have same size for rough cutting
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check if tool radii have the same size in guide and following channel.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61755 %[[channel %1: ] block %2: %]Plate widths are different
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
478
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual