Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 463
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check tool angles (clearance and pitch angles) of the active dressing tool resp. contour.
Use another dressing tool.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61601
[Channel %1: ] Block %2: Finished part diameter too small
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Remedy:
Check parameter SPD or DIATH.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61602
[Channel %1: ] Block %2: Tool width incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Plunge cutter is larger than the programmed groove width.
Remedy:
Check tool or change program.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61603
[Channel %1: ] Block %2: Recess type incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Radii/chamfers at the groove base do not match the groove width. Face groove on a contour element running parallel to
the longitudinal axis is not possible.
Remedy:
Check parameter VARI.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61604
[Channel %1: ] Block %2: Active tool violates programmed contour
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Contour violation in the relief cut elements due to the tool clearance angle of the tool used.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Use a different tool or check the contour subroutine.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61605
[Channel %1: ] Block %2: Contour incorrectly programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Illegal relief cut element detected.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
463
Hide quick links:
Advertisement
Table of Contents
