Data Backup - Siemens SINUMERIK 808D ADVANCED Diagnostic Manual

Data backup

8.1 Internal data backup
You can save the data of the limited-buffered memory via a backup copy to the permanent
memory of the control system. This backup is performed internally and is always necessary if
you need to switch off the control system for longer than 60 hours.
Note
After changing important data, it is recommended to carry out an internal data backup
immediately.
Backing up data internally
Proceed as follows to back up data internally:
Note
While performing an internal data backup, you must neither operate nor turn off the control
system.
Loading internally backed up data
There are two methods to load the internally backed up data.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
1. Select the desired operating area.
+
2. Press this softkey, and the following message prompts:
3. Press this softkey to confirm. The control system begins to save data.
Wait until the progress dialog disappears and the data saving finishes.
8
551