Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 393

Remedy: The stated transformation is not active.
You have to activate the transformation before you can use it.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61148 [Channel %1: ] Block %2: Swivel plane with active turning tool not possible
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Swiveling the plane is not possible when a turning tool is active.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a milling tool before you swivel the plane.
The alarm can be suppressed using SD 55410 $SCS_MILL_SWIVEL_ALARM_MASK.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61149 [Channel %1: ] Block %2: Positioning a milling tool with active turning tool is not possible
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Milling tools cannot be positioned if a turning tool is active.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Load a milling tool, before you call positioning.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61150 [Channel %1: ] Block %2: Tool cannot be aligned - error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Remedy: Error code:
A: Only new swivel plane permitted, see parameter _ST
B: Angular range >= 360 -> angular range of the B axis >= 360 degrees
C: Rotary axis vector V1 is not equal to 0 1 0 -> rotary axis vector V1 must rotate around Y
See setup of swivel CYCLE800
D: Rotary axis vector V2 -> rotary axis vector V2 must rotate around X (1 0 0) or Z (0 0 1)
See setup of swivel CYCLE800
E: WCS ROT Y > 90 -> active rotation of the WCS around Y is >90 degrees. -90 to +90 is permitted
F: If geometry axis Y is not available -> SD55221 set bit 5 = 1
G: Initial setting defines ($TC_CARR37] HUNDREDTHOUSANDS digit -Z or -X) -> SD55221 set bit 5 = 1
See setup of swivel CYCLE800
H: Align tool, active plane not G18
I: 1st turning technology (MD52200=1) and no Y axis available -> mirroring not allowed
J: Grinding technology (MD52200..) -> SD55221 set bit 5 = 1
K: Grinding technology (MD52200..) -> set MD20186 = 1
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
393