Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 379

Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Only program the magazine location (without multitool location).
Programm Clear alarm with the RESET key. Restart part program
continuation:
61064 %[[Channel %1: ] Block %2: %]Invalid multitool location: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: A multitool location was programmed, at which there is no multitool.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program a valid multitool location.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61065 [Channel %1: ] Block %2: A channel specified in the job list does not exist: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: A non-existent channel was specified in the job list.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Correct job list
Programm Clear alarm with the RESET key. Restart part program
continuation:
61066 %[[Channel %1: ] Block %2: %]Cycle %4 requires G code G70 or G71
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Cycle requires G code G70 or G71
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program G70 or G71
Programm Clear alarm with the RESET key. Restart part program
continuation:
61067 [Channel %1: ] Block %2:Tool spindle is in spindle mode: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: To activate the turning transformation, the tool spindle must be in axis mode. But it is in spindle mode.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
379