Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 471

Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check number of contours
- Max. two contours (machined part and blank contours)
- Min. one contour (machined part contour)
Programm Clear alarm with the RESET key. Restart part program
continuation:
61709 %[[Channel %1: ] Block %2: %]Cutting edge radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check cutting edge radius of the tool in tool management
Programm Clear alarm with the RESET key. Restart part program
continuation:
61710 %[[Channel %1: ] Block %2: %]Calculation has been canceled
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Calculation has been canceled by PI service; please try again
Programm Clear alarm with the RESET key. Restart part program
continuation:
61711 %[[Channel %1: ] Block %2: %]Infeed D is larger than the tip width of the tool
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Check infeed D in connection with the tip width of the tool in tool management.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61712 %[[Channel %1: ] Block %2: %]Infeed DX or DZ is larger than tip length of tool
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
471