Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 64
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Explanation:
In the specified machine data, a number has been specified for the configuration of an M function which is occupied by
the system, and cannot be used for an assignment. (M0 to M5, M17, M30, M40 to M45 and also M98, M99 with applied
ISO dialect). The value set by the user has been reset to the default value by the system.
Reaction:
Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Configure an M function in the specified machine data which is not occupied by the system (M0 to M5, M17, M30, M40 to
M45 and also M98, M99 with applied ISO dialect).
Programm
Clear alarm with the RESET key. Restart part program
continuation:
4183
[Channel %1: ] M auxiliary function number %2 used several times (%3 and %4)
Parameters:
%1 = Channel number
%2 = M auxiliary function number
%3 = MD identifier
%4 = MD identifier
Explanation:
In the specified machine data, a number has been used several times for the configuration of an M function.
Reaction:
Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Check the specified machine data and create a unique assignment of M auxiliary function numbers.
Programm
Switch control OFF - ON.
continuation:
4184
[Channel %1: ] Illegally predefined auxiliary function in %2[%3], MD reset
Parameters:
%1 = Channel number
%2 = MD identifier
%3 = If required, MD index
Explanation:
In the specified machine data, a predefined auxiliary function has been illegally configured.
The value set by the user has been reset to the default value by the system.
Reaction:
Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Configure a valid value in the specified machine data.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
4185
[Channel %1: ] Illegal auxiliary function configured %2 %3 %4
Parameters:
%1 = Channel number
%2 = Type of auxiliary function
%3 = Extension
%4 = Auxiliary function value
64
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
