Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 401

Remedy: If tool carrier is active, check commissioning of swivel CYCLE800. Parameter $TC_CARR37[n] 7th and 8th decimal places
n number of swivel data set
If align turning tool with milling/turning machine (transformation on basic kinematic chain) is active,
check parameter $NT_IDENT[n,0] 7th and 8th decimal places (n = name of transformation)
Error code:
A: Retraction Z not set up
B: Retraction Z XY not set up
C: Retraction in tool direction max. not set up
D: Retraction in tool direction incremental not set up
E: Retraction in tool direction: NC function CALCPOSI reports error
For the CALCPOSI function, the axes must be referenced. Check machine data MD20700.
F: Retraction in tool direction: no tool axis available
Missing geometry axis (tool axis) Z with G17, Y with G18 or X with G19
G: Retraction in tool direction max.: negative retraction path
H: Retraction in tool direction incremental: negative retraction path not permitted
I: Retraction commissioning swivel CYCLE800 not set up
J: Retraction in tool direction is not permitted, because current Work (WCS) is mirrored
Tool carrier is active
K: Retraction and swivel plane and transformation on basic kinematic chain are active
Retraction with transformation only if align turning tool is active
L: Retraction in tool direction and align tool are only permitted if SD42954 $SC_TOOL_ORI_CONST_M=0
Transformation on basic kinematic chain is active
M: Retraction in tool direction and align tool are only permitted if SD42956 $SC_TOOL_ORI_CONST_T=0
Transformation on basic kinematic chain is active
N: Retraction in tool direction and swivel plane toward counterspindle are not possible
Turning machine with active tool carrier and initial setting -X (see setup swivel)
O: Retraction in tool direction, align tool with counterspindle is not possible
P: Retraction in tool direction in G18 toward counterspindle is not possible
Q: Retraction in tool direction is not permitted because the current Work (WCS) is mirrored
Align turning tool with milling/turning machine (transformation on basic kinematic chain) active
R: Retraction in tool direction is not possible with align tool
Align turning tool with milling/turning machine (transformation on basic kinematic chain) active
61191 [Channel %1: ] Block %2: Multi-axis transformation not set up. Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Error code:
Number or parameter name of multi-axis transformation
Programm Clear alarm with the RESET key. Restart part program
continuation:
61192 [Channel %1: ] Block %2: Additional multi-axis transformations not set up. Error code: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
401