Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 242

SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
16016 [Channel %1: ] Block %2 no retraction position programmed for axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Explanation: The retraction enable was programmed for LIFTFAST without defining a retraction position for the axis. The retraction
movement is no longer clear.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program a retraction position for the relevant axis.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
16017 [Channel %1: ] Axis %2 Identifier %3, LIFTFAST ignores this axis, current axis not capable of
retraction
Parameters: %1 = Channel
%2 = Axis, spindle
%3 = Identifier
Explanation: LIFTFAST cannot be applied to the axis.
Alarm can be suppressed via MD11415 $MN_SUPPRESS_ALARM_MASK_2 bit 11.
Identifiier (parameter 3) is bit-coded and displays some possible causes for the alarm:
0x01 Axis is in another channel
0x02 Axis is in spindle mode (e.g. SPOS)
0x04 Axis is PLC axis
0x08 Axis is oscillating axis
0x10 Axis is neutral axis
0x20 Axis is coupled slave axis
0x40 Axis is in static synchronized action
Overview of reactions of common programming to LIFTFAST:
Axis | Synact | Reaction to LIFTFAST
-----------------------------------------
Path |
POS |
POS | non-modal | STOP + LIFTFAST
POS | modal | STOP + LIFTFAST
POS | stati. | RUN + SHOWALARM 16017
POSA |
MOV | non-modal | STOP + LIFTFAST
MOV | modal | STOP + LIFTFAST
MOV | stati. | RUN + SHOWALARM 16017
PLC |
Oscill. |
SPOS |
SPOS | non-modal | STOP + SHOWALARM 16017
SPOS | modal | STOP + SHOWALRAM 16017
SPOS | stati. | RUN + SHOWALARM 16017
SPOSA |
Reaction: Alarm display.
242
| STOP + LIFTFAST
| STOP + LIFTFAST
| STOP + LIFTFAST
| RUN + SHOWALARM 16017
| RUN + SHOWALARM 16017
| STOP + SHOWALARM 16017
| STOP + SHOWALARM 16017
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual