Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 195

Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
14097 [Channel %1: ] Block %2 string cannot be converted to AXIS type
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The called function AXNAME - conversion of the transferred parameters of the STRING type to an axis name (return value)
of the AXIS type - has not found this axis identifier in the machine data.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Check the transferred parameter (axis name) of the function
AXNAME to determine whether a geometry, channel or machine axis of this name has been configured by means of the
machine data:
MD10000 $MN_AXCONF_MACHAX_NAME_TAB
MD20060 $MC_AXCONF_GEOAX_NAME_TAB
MD20080 $MC_AXCONF_CHANAX_NAME_TAB
Select the transfer string in accordance with the axis name, and change the axis name in the machine data if necessary.
(If a change of name is to take place via the NC part program, this change must first be validated by means of a "POWER-
ON").
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
14098 [Channel %1: ] Block %2 conversion error: no valid number found
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The string is not a valid INT or REAL number.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program. If it is an entry, then you can check whether the string is a number via the preset function ISNUMBER
(with the same parameter).
Programm Clear alarm with the RESET key. Restart part program
continuation:
14099 [Channel %1: ] Block %2 result in string concatenation too long
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The result of string chaining returns a string which is greater than the maximum string length laid down by the system.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Adapt part program. With the function STRLEN, it is also possible to query the size of the sum string before executing the
chaining operation.
Programm Clear alarm with the RESET key. Restart part program
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
195