Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 406

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: The step "Counterspindle: synchronizing" must be used in the other channels.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61210 [Channel %1: ] Block %2: Block search element not found
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The element specified for the block search does not exisit.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Repeat block search.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61211 [Channel %1: ] Block %2: Absolute reference missing
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: An incremental indication was made, but the absolute reference is unknown.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program an absolute position prior to using incremental indications.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61212 %[[Channel %1: ] Block %2: %]Wrong tool type
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The tool type is not suitable for machining.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select a new tool type.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61213 [Channel %1: ] Block %2: Circle radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The programmed circle radius is too small.
Remedy: Correct the circle radius, center point or end point.
406
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual