Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 502

SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
61952 %[[Channel %1: ] Block %2: %]Radius of res. material cutter too small in relation to ref. cutter
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: - Use a cutter with a larger radius for residual machining
Programm Clear alarm with the RESET key. Restart part program
continuation:
62000 [Channel %1: ] Block %2: Insert new tool
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Please load new tool.
Remedy: --
Programm Clear alarm with the Delete key or NC START.
continuation:
62098 [Channel %1: ] Block %2: %4
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: This alarm is used for various purposes.
Please refer to the alarm text.
Remedy: Depends on alarm text
Programm Clear alarm with the Delete key or NC START.
continuation:
62100 [Channel %1: ] Block %2: No drilling cycle active
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: No modal drilling cycle has been called before the drilling pattern cycle call.
Remedy: Check whether a drilling cycle was called prior to calling the drilling pattern cycle.
Programm Clear alarm with the Delete key or NC START.
continuation:
62101 [Channel %1: ] Block %2: Milling direction incorrect - G3 is generated
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Synchronous or reverse rotation programmed. But the spindle does not rotate at a cycle call.
Remedy: Check value in paramter CDIR.
62102 [Channel %1: ] Block %2: pocket not completely solidly machined during finishing
Parameters: %1 = Channel number
%2 = Block number, label
Explanation:
Reaction: Alarm display.
Remedy:
502
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual