Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 279

Remedy: Check tool call in the NC parts program:
- Correct tool correction number D programmed? If no D number is specified with the tool change command, then the D
number set by MD20270 $MC_CUTTING_EDGE_DEFAULT will be active automatically. It is D1 by default.
- Tool parameters (tool type, length,...) defined? The dimensions of the tool edge must have been entered previously either
through the operator panel or through a tool data file in NCK.
Description of the system variables $TC_DPx[t, d] as included in a tool data file.
x ... Correction parameter number P
t ... Associated tool number T
d ... Tool correction number D
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
17181 [Channel %1: ] Block %2 T no.= %3, D no.= %4 not existing
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
%4 = D number
Explanation: A programmed D number was not recognized by the NC. By default, the D number refers to the specified T number. If the
flat D number function is active, T= 1 is output.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: If the program is incorrect, remedy the error with a correction block and continue the program.
If the data block is missing, download a data block for the specified T/D values onto the NCK (via HMI with overstore) and
continue the program.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
17183 [Channel %1: ] Block %2 H number already available in T no.= %3, D no.= %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = T number
%4 = D number
Explanation: Each H number (except for H=0) must be assigned in a TO unit only once. The indicated edge already has the H number.
If the H number shall be assigned more than once, MD10890 $MN_EXTERN_TOOLPROG_MODE, bit 3 must be set = 1.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: - Change program:
- Select different H number
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
17188 [Channel %1: ] D number %2 defined in tool T no. %3 and %4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = T number of first tool
%4 = T number of second tool
Explanation: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T numbers %3 and %4 each have
an offset with number %2. If tool management is active: The specified T numbers belong to tool groups with different
names.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
279