Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 467
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Check the commissioning of the main spindle.
Check machine data MD20070 $MC_AXCONF_MACHAX_USED, MD20080 $MC_AXCONF_CHANAX_NAME_TAB and
MD52207 $MCS_AXIS_USAGE_ATTRIB bit 8.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61620
[Channel %1: ] Block %2: %4-Mirroring for the linear axis of the counter spindle not permitted
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
It is not permissible that the linear axis of the counterspindle machining has Z mirroring.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Deselect Z mirroring in the WO used.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61621
[Channel %1: ] Block %2: Angle of opening of the convex thread too high
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Convexity of the thread is too high.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check parameter XS or RS
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61622
[Channel %1: ] Block %2: Toolcarrier for turning not set up
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
A toolcarrier was not set up for turning.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Set up a tool with carrier with the rotary axes: B axis and tool spindle.
Set the identifier "B axis kinematics".
Programm
Clear alarm with the RESET key. Restart part program
continuation:
61623
[Channel %1: ] Block %2: A toolcarrier has not been set up for milling on the main spindle
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
A toolcarrier has not been setup for a milling on the main spindle.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
467
Hide quick links:
Advertisement
Table of Contents
