Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 296
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
18005
[Channel %1: ] Block %2 serious error in definition of NCK-specific protection zone %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Protection zone number
Explanation:
The protection zone definition must be terminated with EXECUTE before a preprocessing stop is performed. This also
applies to any that are initiated implicitly such as with G74, M30, M17.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
18006
[Channel %1: ] Block %2 serious error in definition of channel-specific protection zone %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Protection zone number
Explanation:
The protection zone definition must be terminated with EXECUTE before a preprocessing stop is performed. This also
applies to any that are initiated implicitly such as with G74, M30, M17.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
18205
[Channel %1: ] Block %2 motion synchronous action: %3 curve table %4 does not exist
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
%4 = Number of curve table
Explanation:
An attempt was made to use a curve table whose table number is not known in the system \par.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Change the table number in the program instruction or define the curve table with the desired table number.
Programm
Clear alarm with the RESET key. Restart part program
continuation:
18300
[Channel %1: ] Block %2 frame: fine shift not possible
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Allocation of a fine shift to settable frames or the basic frame is not possible since MD18600
$MN_MM_FRAME_FINE_TRANS is not equal to 1.
296
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
