Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 419

Programm Clear alarm with the RESET key. Restart part program
continuation:
61263 [Channel %1: ] Block %2: Chained ShopMill program blocks not permissible in subprogram on
pos. pattern
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reprogram machining.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61264 [Channel %1: ] Block %2: Chained ShopTurn program blocks not permissible in subprogram on
pos. pattern
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Reprogram machining.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61265 [Channel %1: ] Block %2: Too many restrictions, use rectangular pocket
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: In face milling a maximum of only 3 sides can be delimited.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Use pocket cycle.
Programm Clear alarm with the RESET key. Restart part program
continuation:
61266 [Channel %1: ] Block %2: Illegal machining direction
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: In face milling, the delimitations and the direction of machining do not match.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Select another direction of machining.
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
419