Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 239

Explanation: There is an error in the start conditions for CONTPRON/CONDCON:
- G40 not active
- SPLINE or POLY active
- Unknown machining type programmed
- Transferred machining direction not defined
- Definition of LUDs in incorrect subroutine level
- Transferred circle coordinates
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Programm Clear alarm with the RESET key. Restart part program
continuation:
15810 [Channel %1: ] Block %2 wrong array dimension for CONTPRON/CONTDCON
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: The number of columns for the array created for CONTPRON/CONTDCON does not conform to the current programming
guide.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Programm Clear alarm with the RESET key. Restart part program
continuation:
15900 [Channel %1: ] Block %2 touch probe not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Explanation: Measure with deletion of distance-to-go
In the part program, an illegal probe has been programmed with the command MEAS (measure with deletion of distance-
to-go). The probe numbers
0 ... no probe
1 ... probe 1
2 ... probe 2
are allowed, whether the probe is actually connected or not.
Example:
N10 MEAS=2 G01 X100 Y200 Z300 F1000
Probe 2 with deletion of distance-to-go
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Include a probe number within the limits given above in the keyword MEAS=... This must correspond to the hardware
connection of the probe.
Programm Clear alarm with NC START or RESET key and continue the program.
continuation:
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
239