Siemens SINUMERIK 808D ADVANCED Diagnostic Manual page 286
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
17602
[Channel %1: ] Block %2 motion synchronized action: %3 preset not possible on axis %4 in
JOGREF mode
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
%4 = Axis name, spindle number
Explanation:
The actual value cannot be preset for this axis if the mode group to which this axis is assigned is in JOG mode and if the
machine function reference point approach is also selected.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Avoid setting actual value in this configuration or deselect the machine function reference point approach.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
17603
[Channel %1: ] Block %2 motion synchronized action: %3 preset is only possible on a stationary
axis %4 in JOG mode
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
%4 = Axis name, spindle number
Explanation:
In JOG mode, an actual value can only be preset on stationary axes.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Avoid setting an actual value while the axis is in motion; wait until the axis is stationary.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
17604
[Channel %1: ] Block %2 motion synchronized action: %3 preset not possible on active oscillating
axis (axis %4)
Parameters:
%1 = Channel number
%2 = Block number, line number
%3 = Synact ID
%4 = Axis name, spindle number
Explanation:
An actual value cannot be preset on an active oscillating axis controlled via synchronized actions.
Reaction:
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy:
Avoid setting actual value during active oscillating movement.
Programm
Clear alarm with NC START or RESET key and continue the program.
continuation:
17610
[Channel %1: ] Block %2 axis %3 involved in the transformation, action cannot be carried out
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
286
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
Diagnostics Manual
Hide quick links:
Advertisement
Table of Contents
