Link-Delay - H3C S3100 Series Command Manual

Only S3100-EI Series switches support this feature.
The configuration of jumboframe enable command takes effect on all the ports while the
configuration of undo jumboframe enable takes effect on current port.
Example
# Set the maximum frame size allowed on Ethernet 1/0/1 to 2048 bytes.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] jumboframe enable

link-delay

Syntax
link-delay delay-time
undo link-delay
View
Ethernet port view
Parameters
delay-time: Port state change delay to be set. This argument is in the range 2 to 10 (in seconds).
Description
Use the link-delay command to set the port state change delay.
Use the undo link-delay command to restore the default.
By default, the port state change delay is 0 seconds, that is, the port state changes without any delay.
During a short period after you connect your switch to another device, the connecting port may go up
and down frequently due to hardware compatibility, resulting in service interruption.
To avoid situations like this, you may set a port state change delay.
The port state change delay takes effect when the port goes down but not when the port goes up.
The delay configured in this way does not take effect for ports in DLDP down state. For information
about the DLDP down state, refer to DLDP.
Examples
# Set the port state change delay of Ethernet 1/0/5 to 8 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
1-19