Port Hybrid Protocol-Vlan Vlan - H3C S3100 Series Command Manual

port hybrid protocol-vlan vlan

Syntax
port hybrid protocol-vlan vlan vlan-id { protocol-index [ to protocol-index-end ] | all }
undo port hybrid protocol-vlan vlan vlan-id { protocol-index [ to protocol-index-end ] | all }
View
Ethernet port view
Parameters
vlan-id: Specifies the ID of the protocol VLAN bound with the port. The value range is 1 to 4094. At least
one protocol template must have been configured for the VLAN.
protocol-index: Specifies a protocol template, in the range of 0 to 15.
to protocol-index-end: In conjunction with protocol-index, specify a protocol index range. The
protocol-index-end argument takes a value in the range of 0 to 15 and must be greater than
protocol-index.
all: Specifies all protocol indexes. With the all keyword, the port hybrid protocol-vlan vlan command
binds the port with all the protocol templates of the specified protocol VLAN, and the undo form of the
command removes the associations between the port and all the protocol templates of the specified
protocol VLAN.
Description
Use the port hybrid protocol-vlan vlan command to bind the port with the specified protocol
template(s) of a protocol VLAN.
Use the undo port hybrid protocol-vlan vlan command to remove the binding between the port and
the specified protocol template(s) of a protocol VLAN.
The port hybrid protocol-vlan vlan command is available on hybrid ports only.
Before you bind a port with a protocol VLAN, assign the port to the VLAN with the port hybrid vlan
command. Otherwise, the binding will fail.
To bind a protocol template to a port in a VLAN successfully, you must ensure that the protocol
template has been created in the VLAN. If the protocol template you are binding with the port has
not been created in the VLAN, the system will display the operation failure message. If some of the
protocol templates you are binding with the port have not been created in the VLAN, the system
does not display error messages while binding those already created with the port.
When you removes the binding between a port and a protocol template, the system will report
operation failure if the index of the specified protocol to be removed does not exist. If a part of the
specified protocol indexes to be removed do not exist, the switch will remove the existing indexes
when it prompts errors.
Related commands: display protocol-vlan interface.
1-19