H3C S3100 Series Command Manual page 152

Parameter
interface-type: Port type.
interface-number: Port number.
For details about the arguments, refer to the parameter description of the interface command.
Description
Use the display interface command to display port configuration.
When using this command:
If you specify neither port type nor port number, the command displays information about all ports.
If you specify only port type, the command displays information about all ports of the specified type.
If you specify both port type and port number, the command displays information about the specified
port.
Example
# Display the configuration information of Ethernet 1/0/1.
<Sysname> display interface ethernet1/0/1
Ethernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0012-a990-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 2048
Broadcast MAX-bps: 128K
Multicast MAX-bps: 128K
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 300 seconds input:
Last 300 seconds output:
Input(total):
0 broadcasts, 0 multicasts, 0 pauses
Input(normal):
0 broadcasts, 0 multicasts, 0 pauses
Input: 0 input errors, 0 runts, 0 giants,
0 frame,
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): 0 packets, - bytes
0 broadcasts, 0 multicasts, - pauses
Output: 0 output errors,
0 aborts, 0 deferred, 0 collisions, 0 late collisions
- lost carrier, - no carrier
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
0 packets, 0 bytes
- overruns, 0 aborts, - ignored, - parity errors
- underruns, - buffer failures
- throttles, 0 CRC
1-7