H3C S3100 Series Command Manual page 73

Hide thumbs Also See for S3100 Series:

Table of Contents

vlan-id1: Specifies the ID of the VLAN you want to create or remove, in the range of 1 to 4094.

to vlan-id2: In conjunction with vlan-id1, specify a VLAN ID range you want to create or remove. The

vlan-id2 argument takes a value in the range of 1 to 4094, and must not be less than that of vlan-id1.

all: Creates or removes all existing VLANs except those configured with other functions.

Use the vlan command to create VLANs. If you create only one VLAN, you enter the view of the VLAN

upon its creation; if the specified VLAN already exists, you enter its VLAN view directly.

Use the undo vlan command to remove VLANs.

By default, only VLAN 1 exists in the system.

VLAN 1 is the default VLAN and cannot be removed.

You cannot use the undo vlan command to directly remove the VLANs reserved by the protocol,

voice VLAN, control VLANs for Smart Link, probe VLANs for remote mirroring, or VLANs used for

performing any other features. To remove them, you must remove the associations of them with

the features.

After you use the undo vlan command to remove a VLAN functioning as the default VLAN of a

trunk or a hybrid port, the configuration of the default VLAN on the trunk port or hybrid port does not

change. The port will continue to use the removed VLAN as its default VLAN.

# Create VLAN 5 and enter its VLAN view.

<Sysname> system-view

System View: return to User View with Ctrl+Z.

[Sysname] vlan 5

[Sysname-vlan5]

# Remove VLAN 5.

[Sysname-vlan5] quit

[Sysname] undo vlan 5

# Create VLAN 4 through VLAN 100.

[Sysname] vlan 4 to 100

Please wait............. Done.

# Remove VLAN 2 through VLAN 9 in bulk. VLAN 7 is the voice VLAN.

[Sysname] undo vlan 2 to 9

Note:The VLAN kept by protocol, the voice VLAN, the default VLAN, the management VLAN and

the remote probe VLAN will not be deleted!

Please wait... Done.

[Sysname] display vlan

The following VLANs exist:

1(default), 7

Chapters

Table of Contents