Port Access Vlan - H3C S3100 Series Command Manual

The command applies to access ports only. For information about how to assign to or remove from a
VLAN trunk or hybrid ports, refer to the
command . For port type configuration, refer to the
Related commands: display vlan.
Examples
# Assign Ethernet1/0/2 through Ethernet1/0/4 to VLAN 2.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vlan 2
[Sysname-vlan2] port Ethernet 1/0/2 to Ethernet 1/0/4

port access vlan

Syntax
port access vlan vlan-id
undo port access vlan
View
Ethernet port view
Parameters
vlan-id: Specifies the ID of the VLAN to which you want to assign the current port, in the range of 1 to
4094. The specified VLAN must already exist.
By default, all access ports belong to VLAN 1. You cannot assign an access port to or remove an
access port from VLAN 1 with the port access vlan command or its undo form. To assign an access
port that has been assigned to a VLAN other than VLAN 1, you can use the undo port access vlan
command.
Description
Use the port access vlan command to assign the current access port to the specified VLAN.
Use the undo port access vlan command to remove the access port from the specified VLAN. After
that, the access port joins VLAN 1 automatically.
Examples
# Assign Ethernet 1/0/1 to VLAN 3.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] port access vlan 3
port hybrid vlan command and the
port link-type
1-9
port trunk permit vlan
command .