Copy Configuration - H3C S3100 Series Command Manual

If you configure broadcast-suppression command in both system view and Ethernet port view,
the configuration in Ethernet port view will take effect.
If the broadcast traffic threshold configured by using the broadcast-suppression pps max-pps
command in system view is greater than the maximum broadcast traffic rate allowed on an
Ethernet port, the maximum broadcast traffic rate allowed takes effect on the port.
With traffic policing enabled, broadcast-suppression function cannot be enabled either on
System view or Ethernet port view. Refer to the QoS part for information about Traffic Policing.
Example
# Allow incoming broadcast traffic on each port to occupy up to 20% of the total transmission capacity of
the port and suppress the broadcast traffic that exceeds this threshold.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] broadcast-suppression 20
Note:Broadcast-suppression is set successfully on all ports except reflector ports, fabric
ports and the port configured storm-constrain!
# Set the maximum rate of incoming broadcast bits allowed on Ethernet 1/0/2 to 128 kbps.
[Sysname] interface Ethernet 1/0/2
[Sysname-Ethernet1/0/2] broadcast-suppression bps 128

copy configuration

Syntax
copy configuration source { interface-type interface-number | aggregation-group source-agg-id }
destination { interface-list [ aggregation-group destination-agg-id ] | aggregation-group
destination-agg-id }
View
System view
Parameter
interface-type: Port type.
interface-number: Port number.
source-agg-id: Source aggregation group number, in the range of 1 to 52. The port with the smallest
port number in the aggregation group is used as the source port.
destination-agg-id: Destination aggregation group number, in the range of 1 to 52.
interface-list: Destination port list, interface-list = interface-type interface-number [ to interface-type
interface-number ] &<1-10. &<1-10> means that you can input up to 10 ports/port ranges.
Description
Use the copy configuration command to duplicate the configuration of a port to specified ports to keep
consistent configuration on them.
1-2