H3C S3100 Series Command Manual page 47

Manage level: Commands at this level are for the operation of the entire system and the system
supporting modules. Services are supported by these commands. Commands concerning file
system, file transfer protocol (FTP), trivial file transfer protocol (TFTP), downloading using
XModem, user management, and level setting are at administration level.
Refer to CLI Configuration for information about command level.
Examples
# Configure that commands at level 1 are available to the users logging in to VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 1
# You can verify the above configuration by Telnetting to VTY 0 and displaying the available commands,
as listed in the following.
<Sysname> ?
User view commands:
cluster
debugging
display
msdp-tracert
mtracert
nslookup
ping
quit
reset
send
super
telnet
terminal
tracert
undo
Run cluster command
Enable system debugging functions
Display current system information
MSDP trace route to source RP
Trace route to multicast source
Query Internet name servers
Ping function
Exit from current command view
Reset operation
Send information to other user terminal interfaces
Set the current user priority level
Establish one TELNET connection
Set the terminal line characteristics
Trace route function
Cancel current setting
1-26