H3C S3100 Series Command Manual page 148

If you specify a source aggregation group ID, the system uses the port with the smallest port
number in the aggregation group as the source.
If you specify a destination aggregation group ID, the configuration of the source port will be copied
to all ports in the aggregation group and all ports in the group will have the same configuration as
that of the source port.
The configuration that can be copied includes: VLAN configuration, protocol-based VLAN configuration,
LACP configuration, QoS configuration, GARP configuration, STP configuration and initial port
configuration.
VLAN configuration: includes IDs of the VLANs allowed on the port and the default VLAN ID of the
port;
Protocol-based VLAN configuration: includes IDs and indexes of the protocol-based VLANs
allowed on the port;
Link aggregation control protocol (LACP) configuration: includes LACP enable/disable status;
The copy configuration command can only be used to copy the configuration of LACP's enable state,
but not to copy the configuration of the aggregation group. In other words, you cannot add a port to the
aggregation group by using this command.
QoS configuration: includes Traffic Policing, Packets Priority Marking, Port Priority, Traffic
Statistics, Traffic Redirecting, Port Rate Limiting, Priority Trust Mode, and QoS Profile ( excludes
qos-profile port-based );
STP configuration: includes STP enable/disable status on the port, link attribute on the port
(point-to-point or non-point-to-point), STP priority, path cost, packet transmission rate limit,
whether loop protection is enabled, whether root protection is enabled, and whether the port is an
edge port;
Generic attribute registration protocol (GARP) configuration: includes GVRP enable/disable status,
timer settings, and registration mode;
Port configuration: includes link type of the port, port rate and duplex mode.
In case a configuration setting fails to be copied, the system will print the error message.
1-3