Commands In The Global Configuration Mode; Auto-Save - Siemens SCALANCE W760 Configuration Manual

Configuration
3.4 Configuration Save & Restore
Result
The changes are saved in the configuration file.
Use the
Further notes
You enable the auto save function or disable the Trial mode with the
You disable the auto save function or enable the Trial mode with the
command.
3.4.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.4.3.1

auto-save

Description
The CLI can save changes to the configuration automatically.
If you first want to test changes made to the configuration so that you can discard them
afterwards if necessary, you can disable the auto save function.
You are then in the Trial mode.
Changes to the configuration that you have not saved, are indicated by an asterisk in front of
the command prompt:
You save the changes to the configuration with the
With the
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
78
command without parameters to restart the system with this configuration.
restart
*cli(...)#
command, you enable the auto save function.
auto-save
configure terminal
or
end exit
.
write startup-config
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
auto-save
no auto-save
command to change to this mode.
command and are then in the
command.