Ip Address Dhcp - Siemens SCALANCE W760 Configuration Manual

Syntax
Call up the command with the following parameters:
no ip address [{ <ucast_addr>}]
The parameter has the following meaning:
Parameter
ucast_addr
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The assignment of the IP address to a VLAN interface is deleted and DHCP is disabled.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, you can lose the connection!
Further notes
You configure the setting with the
You display this setting and other information with the
7.1.3.3

ip address dhcp

Description
With this command, the VLAN interface obtains the IP address via DHCP.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameters:
ip address dhcp
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
Description
IP Address of the VLAN interface that will
be deleted
ip address
Values
enter a valid IP address
command.
show ip interface
Network protocols
7.1 IPv4 protocol
command.
275