Ip Name-Server - Siemens SCALANCE W760 Configuration Manual

7.1.2.11

ip name-server

Description
This command specifies an IP address of a DNS server. If there is more than one server,
you can specify the order in which the servers are queried. To allow this, the optional
parameter
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip name-server ipv4 <ucast_addr> [index <id(1-3)>]
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
index
id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The IP address and, if specified, the index for a DNS server has been set.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
is available. The server with the lowest index is queried first.
index
Description
Keyword for IPv4
IP address of the DNS server
Keyword for the index
Index of the DNS server
Network protocols
7.1 IPv4 protocol
Range of values / note
-
Enter a valid IP address
-
1 ... 3
271