No Wlan Data Rates-11N Selected Only (Access Point) - Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11n or IEEE 802.11n only is set.
Syntax
Call the command without parameter assignment:
wlan data rates-11n selected only
Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
You configure the data transmission speeds with the
You configure the transmission standard with the
6.1.5.25

no wlan data rates-11n selected only (access point)

Description
With this command, you enable / disable the automatic selection of the data transmission
speed.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11n or IEEE 802.11n only is set.
162
command.
show wlan data rates
no wlan data rates-11n selected only
wlan data rate-11n
wlan mode
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
command.
command.
command.